Jkg capacitor instruction manual

How do I set up a capacitor bank?

See the specific regulator manual or quick guide used for the capacitor bank. The manual or quick guide is always provided with the capacitor bank Make sure that there are no damaged segments on the display (abnormal brightness). Enter Setup and check the adjusted values. Force the manual connection and disconnection of a step.

How does a capacitor bank work?

The capacitor bank has a manual internal four-pole isolator, but it must be connected to a line that is protected by a circuit breaker as well as earth leakage protection at the header, in ac-cordance with Spanish Low-Voltage Electrotechnical Regulations (LVR) and depending on the earthing system of the installation.

How to adjust the regulator incorporated to the capacitor bank?

In order to adjust the regulator incorporated to the capacitor bank and for opti-mum start-up, the installation load must be at least 30% or 40% of the nominal load for which the capacitor bank has been dimensioned. If all the stages are not included, they can be manually connected to check them all.

Do automatic capacitor banks include a power factor regulator?

The automatic capacitor banks include a power factor regulator. The operation of said regulator must be known prior to start-up; for this reason, all the capacitor banks include a specific manual for the regulator used. Ensure you have this manual available for the start-up process.

How do I check if my capacitors are working properly?

Force the connection and disconnection of the capacitors in manual mode. (refer to the reg-ulator's manual before carrying out these actions) and perform the following checks: . Check that the contactors connect and disconnect properly. Check that the contactor, once connected, does not rattle or vibrate.

How to feed cables into a capacitor bank cabinet?

For feeding cables into the capacitor bank cabinet, always and only use the cable entry points available for this purpose. All models have a cable entry point on the bottom (base of the cabinet) as well as a cable entry point on the side. Figure 4 shows the cable entry points of the OPTIM FRS P&P models.